RAM 3500 Truck 2WD V8-5.9L VIN 5 HDC (2000)
Retaining Pin
5. A retaining pin is located at side of key cylinder assembly.
a. Rotate key to RUN position.
b. Press in on retaining pin while pulling key cylinder from ignition switch.
INSTALLATION
If installing ignition key lock cylinder only, proceed to following steps 2, 3 and 4. Also refer to following steps 12 through 18. If installing both switch
and key cylinder, refer to steps 1 through 18.
Flag in RUN Position
Key Cylinder - Rear View
1. Rotate flag on rear of ignition switch until in RUN position.This step must be done to allow tang on key cylinder to fit into slots within ignition
switch.
