RAM 3500 Truck 2WD V8-5.9L VIN 5 HDC (2000)
Fig. 143
7. Hold accumulator housing firmly in place and install remaining two attaching screws. Be sure springs and clutch valve plug are properly seated
(Fig. 143). Tighten screws to 4 Nm (35 in. lbs.).
VALVE BODY FINAL
1. Install boost valve, valve spring, retainer and cover plate. Tighten cover plate screws to 4 Nm (35 in. lbs.) torque.
2. Insert manual lever detent spring in upper housing.
Fig. 144
3. Position detent ball on end of spring. Then hold detent ball and spring in detent housing with Retainer Tool 6583 (Fig. 144).
4. Install throttle lever in upper housing. Then install manual lever over throttle lever and start manual lever into housing.
5. Align manual lever with detent ball and manual valve. Hold throttle lever upward. Then press down on manual lever until fully seated. Remove
detent ball retainer tool after lever is seated.
6. Then install manual lever seal, washer and E-clip.
