RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Cruise Control Switch: Service and Repair
REMOVAL
WARNING: BEFORE BEGINNING ANY AIRBAG SYSTEM COMPONENT REMOVAL OR INSTALLATION, REMOVE AND
ISOLATE THE NEGATIVE (-) CABLE(S) FROM THE BATTERY. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG
SYSTEM. THEN WAIT TWO MINUTES FOR SYSTEM CAPACITOR TO DISCHARGE BEFORE FURTHER SYSTEM SERVICE.
FAILURE TO DO THIS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE INJURY.
1. Disconnect and isolate negative battery cable(s).
2. Remove airbag module. Refer to Restraint Systems for procedures.
Speed Control Switches
3. Remove switch-to-steering wheel mounting screws.
4. Remove switch.
5. Remove electrical connector at switch.
INSTALLATION
1. Install electrical connector to switch.
2. Install switch and mounting screws.
3. Tighten screws to 3 Nm (26 in. lbs. ± 2 in. lbs.) torque.
4. Install airbag module Refer to Restraint Systems for procedures
5. Connect negative battery cable(s).
