RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in an accidental airbag deployment and possible personal injury or death.
NOTE: Regular Cab model shown. Other models similar.
1. Remove the HVAC housing from the vehicle.
2. Remove the screws (3) that secure the floor distribution duct (1) to the bottom of the HVAC housing (2).
3. Remove the floor distribution duct from the HVAC housing.
Installation
INSTALLATION
NOTE: Regular Cab model shown. Other models similar.
1. Position the floor distribution duct (1) onto the bottom of the HVAC housing (2).
2. Install the screws (3) that secure the floor distribution duct to the HVAC housing. Tighten the screws to 1.1 Nm (10 in. lbs.).