dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Removal and Replacement|Page 12663 > < Removal and Replacement|Page 12661
Page 6
background image

4. Reach up into the instrument panel between the upper glove box opening reinforcement and the cross car beam (4) to access and disconnect the

instrument panel wire harness connector (2) from the airbag inflator pigtail wire connector on the right side of the instrument panel airbag support
bracket. To disconnect the connector:
a. Slide the red Connector Position Assurance (CPA) lock on the top of the connector toward the side of the connector.
b. Depress the connector latch tab and pull the two halves of the connector straight away from each other.

5. Remove the two screws (3) that secure the passenger airbag lower bracket to the instrument panel airbag support bracket.

6. Disengage the airbag inflator pigtail wire connector (1) from the plastic push-in retainer plate (3) on the right side of the instrument panel airbag

support bracket. To disengage the connector:
a. Using a small screwdriver (4), carefully pry the leading edge of the push-in retainer plate away from the connector insulator far enough to clear

the engagement tab (2) on the insulator.

b. Pull the connector toward you to slide it off of the push-in retainer plate.

7. Using a trim stick (2) or another suitable wide flat-bladed tool, gently pry the forward, then the outboard edges of the passenger airbag door (1)

away from the instrument panel (3) far enough to disengage the snap features on the door from the receptacles in the instrument panel base trim.

8. Remove the passenger airbag and airbag door from the instrument panel as a unit.

Installation

INSTALLATION

WARNING:  To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.

WARNING:  To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the passenger airbag, or
becoming entrapped between the passenger airbag cushion and the passenger airbag door. Failure to observe this warning could result in
occupant injuries upon airbag deployment.

Removal and Replacement|Page 12663 > < Removal and Replacement|Page 12661