RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
9. Reinstall the upper trim (2) onto the inside of the B-pillar
10. Position the seat belt turning loop (5) onto the height adjuster (1) on the upper B-pillar.
11. Install and tighten the screw (4) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
12. Engage the upper edge of a new trim cover (3) over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
13. Position the seat belt (2) lower anchor to the mounting hole on the outboard side of the front seat (1) cushion frame. Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
14. Install and tighten the screw (3) that secures the lower anchor to the seat. Tighten the screw to 39 Nm (29 ft. lbs.).
15. Reinstall the lower anchor cover (4) onto the front seat cushion outboard side shield.
16. Reinstall the stowage tray onto the rear floor panel behind the seat.
17. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
Rear Center - Mega Cab
REAR CENTER - MEGA CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.