RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
The combination, dual function Intake Manifold Air Temperature Sensor/MAP (IAT/MAP) (3) sensor is installed into the intake air connection
manifold, below, and to the rear of the EGR valve (5).
1. Clean area around sensor.
2. Disconnect electrical connector (2) from IAT/MAP sensor.
3. Remove mounting screw (4).
4. Remove sensor from manifold.
5. Check condition of sensor O-ring.
Cab/Chassis Models
INSTALLATION-CAB/CHASSIS MODELS
1. Check condition of sensor O-ring.
2. Clean sensor mounting area at intake manifold.
3. Lubricate sensor O-ring and sensor mounting hole in intake manifold cover with clean engine oil.
4. Position sensor (4) into intake manifold.
5. Install and tighten sensor mounting screw (5) to 1 Nm (9 in. lbs.) torque.
6. Connect electrical connector (3) to sensor.
Pick Up Models
INSTALLATION-PICK UP MODELS