RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
1. Install the ball joint (3) into the upper control arm (4) and press in using special tools C-4212-F (press) (1), 9652 (Driver) (2) and 8445-1
(Receiver) (5).
2. Install the upper ball joint into the knuckle.
3. Install the upper ball joint retaining nut and tighten to 54 Nm (40 ft. lbs.)(on 1500 series only an additional 90° turn is required) or 68 Nm (50 ft.
lbs.)(HD).
4. Install the wheel speed sensor wire to the knuckle (HD) and to the upper control arm (LD).
5. Install the tire and wheel.
6. Remove the supports and lower the vehicle.
7. Perform a wheel alignment.