RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Control Arm Bushing: Service and Repair
Removal
Upper Control Arm Bushings - IFS (HD)
UPPER CONTROL ARM BUSHINGS - IFS (HD)
1. Remove the upper control arm.
2. Secure the control arm in a soft jaw vise.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and
insure proper operation during the removal and installation process.
3. Remove the bushing (3) from the upper control arm (5) using special tool C-4212F (PRESS) (1), 9777-3 (receiver) (4), and 9777-2 (driver) (2).
Lower Control Arm Shock Bushing - IFS 4X4
LOWER CONTROL ARM SHOCK BUSHING - IFS 4X4
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Support the lower control arm outboard end.
4. Remove the caliper adapter with the caliper.
5. Remove the rotor.
6. Remove the upper ball joint retaining nut and separate the upper ball joint (4) from the knuckle (6) using separator 9360 (5).
