RAM 3500 Truck 4WD V8-360 5.9L VIN 5 Magnum (1998)
Tensioner Dowel Pin-5.9L HDC-Gas Engine
Tensioner Mounting Bracket Dowel Hole-5.9L HDC-Gas Engine
10. 5.9L HDC-Gas: Install automatic belt tensioner assembly to mounting bracket. A dowel pin is located on back of tensioner. Align this to dowel
hole in tensioner mounting bracket. Tighten bolt to 41 Nm (30 ft. lbs.) torque.
11. Install drive belt.
CAUTION: When installing the serpentine accessory drive belt, the belt must be routed correctly. If not, the engine may overheat due to the
water pump rotating in the wrong direction. The correct belt with the correct length must be used.
12. Install air cleaner assembly.
13. Install upper radiator hose to radiator.
14. Connect throttle cable to clip at radiator fan shroud.
15. Connect wiring harness to A/C compressor.
16. Fill cooling system.
17. Start and warm the engine. Check for leaks.
