RAM 3500 Truck 4WD V8-360 5.9L VIN 5 Magnum (1998)
Tightening Pinion Nut
12. Use Yoke Holder 6719 to retain the yoke. Tighten the nut in 6.8 Nm (5 ft. lbs.) until the rotating torque is achieved. Measure the preload torque
frequently to avoid over-tightening the nut.
Check Pinion Gear Rotation Torque
13. Check bearing preload torque with an inch pound torque wrench. The torque necessary to rotate the pinion gear should be:
-
Original Bearings - 1 to 3 Nm (10 to 20 inch lbs.).
-
New Bearings - 2 to 5 Nm (15 to 35 inch lbs.).
FINAL ASSEMBLY
After pinion gear depth, differential bearing preload, and gear lash has been determined, install the pinion gear and differential assembly and proceed
with this procedure.
1. Install the axle shafts. Refer to Axle Shaft Installation.
