dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Accessories and Optional Equipment > < Seat Belt Buckle Switch|Diagrams|Page 7066
Page 1
background image

Seat Belt Buckle Switch: Testing and Inspection

WARNING:  ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.

1. Check the fuse in the junction block. If OK, go to Step 2. If not OK, repair the shorted circuit or component as required and replace the faulty fuse.
2. Turn the ignition switch to the ON position. Check for battery voltage at the fuse in the junction block. If OK, go to Step 3. If not OK, repair the

open circuit to the ignition switch as required.

3. Turn the ignition switch to the OFF position. Disconnect and isolate the battery negative cable. Unplug the wire harness connector from the driver

seat belt retractor. Check for continuity between the fused ignition switch output (run/start) circuit cavity in the body half of the driver seat belt
switch wire harness connector and the fuse in the junction block. There should be continuity. If OK, go to Step 4. If not OK, repair the open circuit
as required.

4. Check for continuity between the two cavities in the seat belt half of the driver seat belt switch wire harness connector. There should be no

continuity with the seat belt webbing retracted, and continuity with the seat belt webbing pulled out of the retractor far enough to engage the seat
belt buckle. If OK, go to Step 5. If not OK, replace the faulty driver side seat belt and retractor assembly.

5. Remove the instrument cluster from the instrument panel. Check for continuity between the seat belt switch sense circuit cavities of the instrument

cluster wire harness connector (connector B) and the body half of the driver seat belt switch wire harness connector. There should be continuity. If
OK, see Instrument Cluster in the Diagnosis and Testing  for diagnosis of the chime request circuit. If not OK, repair the open circuit as required.

Accessories and Optional Equipment > < Seat Belt Buckle Switch|Diagrams|Page 7066