RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Front Bumper Cover / Fascia: Service and Repair
Front Bumper Fascia - Removal
REMOVAL
ST/SLT/SLT+
1. Remove the two screws (4) at each trailing edge of the fascia.
2. Remove the four push pin fasteners (5) from the upper edge of the close out panel.
3. Using a trim stick (special tool #C-4755) or equivalent, carefully release the six lower clips and remove the close out panel.
4. Using a trim stick or equivalent, carefully remove the step pad (1).
5. Remove and discard the four push pin fasteners (5) and remove the fascia.
SPORT
1. Raise and support the vehicle See: Maintenance.
