RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: Clean slide pin bores thoroughly to remove any old grease.
NOTE: Use grease packets included with kit or Dow Corning-807(R) grease.
1. Thoroughly coat the new slide pins (3) on all working surfaces.
2. Install the boot (2) onto the slide pin (3) and then insert into the adapter (1).
3. Push the pin (3) all the way into the adapter (1) and carefully expel the trapped air by gently pushing on the boot (2) near the slide pin head (3).
NOTE: 4500, 5500 heavy duty trucks use special tool #10050 wrench.
4. Install the caliper adapter mounting bolts (5). For Cab Chassis tighten to 339 Nm (250 ft.lbs.). For 4500, 5500 tighten to 530 Nm (400 ft.lbs.).
5. Install the brake pads See: Brake Pad/Service and Repair/Removal and Replacement/Brake Pads - Installation.
6. Install the caliper (2) and the caliper slide pin bolts (1) See: Disc Brake Caliper - Installation.
7. Install the tire and wheel assembly. See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
8. Remove the support and lower the vehicle.
Rear
REAR