RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
1. Clean the caliper mounting adapter and anti-rattle springs.
2. Lubricate the anti-rattle springs with Mopar brake grease.
NOTE: Anti-rattle springs are not interchangeable.
3. Install new anti-rattle springs.
4. Install the brake pads (2) in adapter.
5. Tilt the bottom of the caliper (3) over rotor (1) and under adapter and push the top of the caliper down onto the adapter.
6. Install the caliper (6) See: Brake Caliper/Service and Repair/Removal and Replacement/Disc Brake Caliper - Installation.
7. Install the wheel and tire assemblies See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
8. Remove the support and lower the vehicle.
9. Apply the brakes several times to seat caliper pistons and brake pads and obtain firm pedal.
10. Top off the master cylinder fluid level.