RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
4. Install the master cylinder (3) on the mounting studs. and tighten the mounting nuts (4) to 23 Nm (17 ft. lbs.).
5. Install the brake lines (5) to the master cylinder (3) and tighten to 19 Nm (170 in. lbs.).
6. Install the hydraulic booster pressure lines (2) to the booster.
7. Tighten the pressure lines (2) to 41 Nm (30 ft. lbs.). NOTE: Inspect o-rings on the pressure line fittings to insure they are in good condition
before installation. Replace o-rings if necessary.
8. Install the return hose to the booster.
9. Bleed base brake system, See: Brake Bleeding/Service and Repair.
10. Fill the power steering pump with fluid, See: Steering and Suspension/Steering/Power Steering/Power Steering Bleeding/Service and Repair.
CAUTION: MOPAR (MS-9602) ATF+4 is to be used in the power steering system. No other power steering or automatic transmission
fluid is to be used in the system. Damage may result to the power steering pump and system if any other fluid is used, and do not overfill.
11. Bleed the hydraulic booster See: Procedures.