RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Valve: Procedures
VALVES, GUIDES AND SPRINGS
REMOVAL
1. Remove cylinder head See: Service and Repair/Removal and Replacement/Cylinder Head - Removal.
2. Support cylinder head on stands, or install head bolts upside down (through combustion surface side) to protect injector tips from damage from
work bench.
3. Install the valve spring compressor base 8313A (1) as shown.
4. Install the valve spring compressor 8319A top plate, washer, and nut. Using a suitable wrench, tighten the nut (clockwise) to compress the valve
springs and remove the locks.
5. Rotate the compressor nut counter-clockwise to relieve tension on the springs. Remove the spring compressor (1).
