RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
4. Align the pulley and bearing assembly (1) squarely onto the front of the A/C compressor (2).
NOTE: A distinct change of sound during the clutch pulley tapping process indicates that the pulley and bearing assembly has bottomed out
against the compressor housing.
5. Using Clutch Pulley Installer 9355 (3) and a hammer (4), install the pulley and bearing assembly onto the front of the A/C compressor. Tap the
installer with a hammer until the pulley and bearing assembly has bottomed against the compressor housing.
CAUTION: If the snap ring is not fully seated in the groove it will vibrate out, resulting in clutch failure and severe damage to the A/C
compressor.
NOTE: Install the snap ring with the beveled side of the snap ring facing outward.
6. Using A/C Snap Ring Pliers 9764 (1) or equivalent, install the snap ring (2) that secures the pulley and bearing assembly (3) to the front of the A/C
compressor (4). Make sure the snap ring is properly seated in the groove.
