RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Coupler HVAC: Service and Repair
Refrigerant Line Coupler - Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow these instructions may result in possible serious or
fatal injury.
1. Recover the refrigerant system See: Service and Repair/Refrigerant System Recovery.
2. Remove the secondary retaining clip from the spring-lock type refrigerant line coupler.
3. Fit the proper size A/C Line Disconnect Tool 7193 or equivalent over the coupler cage (1).
4. Close the two halves of the A/C Line Disconnect Tool 7193 or equivalent around the coupler (2).
NOTE: The garter spring may not release if the A/C Line Disconnect Tool 7193 is not squarely inserted into the coupler cage opening.
5. Push the A/C Line Disconnect Tool 7193 or equivalent into the open side of the coupler cage to expand the garter spring (3). Once the garter
spring is expanded, pull on the refrigerant line attached to the female half of the coupler until the flange on the female fitting is separated from the
garter spring and cage on the male fitting.
6. Open and remove the A/C Line Disconnect Tool 7193 or equivalent from the refrigerant line coupler (4).