RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: Route the wire lead for the evaporator temperature sensor into the opening located on the upper half of the HVAC housing prior to
installing the lower half of the HVAC housing.
9. Position the two halves of the HVAC housing together (3).
10. Install the fifteen screws (6) that secure the two housing halves together. Tighten the screws to 1.1 Nm (10 in. lbs.).
11. Install the foam seal (4) onto the evaporator condensate drain tube (5).
12. Connect the linkage rod (1) to the two blend-air door levers (2) located on the back of the HVAC housing.
13. Position the front floor distribution duct (1) to the bottom of the HVAC housing (2).
14. Install the screws (3) that secure the front floor distribution duct to the HVAC housing. Tighten the screws to 1.1 Nm (10 in. lbs.).
