RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: The engine has a self-priming low-pressure fuel system See: Powertrain Management/Fuel Delivery and Air Induction/Service and
Repair/Fuel System Priming
1. Install fuel filter housing (2) to engine block. Tighten bolts (1) to 32 Nm (24 ft. lbs.).
2. Connect the fuel heater harness connector (1).
3. Connect the Water In Fuel (WIF) sensor harness connector (2).
4. Install all low-pressure fuel lines at filter housing.