RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Switch/Service and Repair/A/C Pressure Transducer - Removal.
A/C Discharge Line - Installation
INSTALLATION
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system See: Heating and Air Conditioning/Service
and Repair/Refrigerant Oil Level . Failure to properly adjust the refrigerant oil level will prevent the A/C system from operating as
designed and can cause serious A/C compressor damage.
NOTE: When replacing multiple A/C system components, see the Refrigerant Oil Capacities chart to determine how much oil should be added
to the refrigerant systemSee: Heating and Air Conditioning/Service and Repair/Refrigerant Oil Level .
NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is disconnected. Failure to replace
the rubber O-ring seals and metal gaskets could result in a refrigerant system leak.
NOTE: The A/C discharge line for the 6.7L Diesel engine is serviced as an assembly with the A/C suction line.
1. If removed, install the A/C pressure transducer (4) onto the A/C suction and discharge line assembly (3) See: Heating and Air
Conditioning/Refrigerant Pressure Sensor / Switch/Service and Repair/A/C Pressure Transducer - Installation.
2. Remove the tape or plugs from the opened refrigerant line fittings and the condenser and compressor ports.
3. Position the A/C suction and discharge line assembly into the engine compartment.
4. Lubricate new O-ring seals with clean refrigerant oil and install them and new gaskets onto the refrigerant line fittings. Use only the specified
O-ring seals as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C
compressor in the vehicle.
5. Connect the A/C suction and discharge line assembly to the A/C condenser (1).
6. Install the nut (2) that secures the A/C discharge line to the A/C condenser. Tighten the nut to 23 Nm (17 ft. lbs.).
7. Connect the A/C suction and discharge line assembly to the A/C compressor (6).
8. Install the bolt (7) that secures the A/C suction and discharge line assembly to the A/C compressor. Tighten the bolt to 23 Nm (17 ft. lbs.).
9. Connect the wire harness connector (5) to the A/C pressure transducer.
