RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Wheel Bearing: Service and Repair
Installation
3500 CAB CHASSIS
NOTE: All views are typical.
1. Position the brake shield (1) on bolts.
2. Install the hub/bearing to the knuckle and tighten the hub/bearing bolts (2) to specifications See: Specifications/Front Suspension Specifications.
3. Install the hub nut and tighten to specifications See: Specifications/Front Suspension Specifications.
4. Install the wheel speed sensor to the hub See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Wheel Speed Sensor - Installation.
5. Install the disc brake rotor See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation.
6. Install the brake caliper adapter with the caliper See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal
and Replacement/Disc Brake Caliper Adapter - Installation.
7. If equipped, install the hub extension and nuts to the front rotor and tighten nuts to specifications See: Specifications/Front Suspension
Specifications.
8. Install the wheel and tire assemblies See: Wheels and Tires/Wheels/Service and Repair.
9. Remove the support and lower the vehicle.
10. Apply the brakes several times to seat the brake shoes and caliper piston. Do not move the vehicle until a firm brake pedal is obtained.