RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Transmission Cooler: Service and Repair
Water To Oil Cooler - Installation
WATER-TO-OIL COOLER
1. Position oil cooler (1) on cylinder block.
2. Install 2 capscrews to cylinder block finger tight.
3. Install capscrews at the transmission adapter. Torque bolt to 24 Nm (18 ft. lbs.)
4. Tighten lower mounting bolt to cooler at the cylinder block. Tighten to 77 Nm (57 ft. lbs.).
NOTE: Use a back-up wrench on the transmission cooler fittings to prevent damage to the cooler.
5. Tighten upper mounting bolt to cooler at cylinder block to 24 N.m (18 ft. lbs).
6. Install wire harness push in clip at bottom of cooler bracket.
7. Install starter motor See: Starting and Charging/Starting System/Starter Motor/Service and Repair/Starter - Installation.
8. Connect battery negative cables.
9. Fill cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
10. Check transmission oil level and fill as necessary.