RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
8. Position the boot (2) on the housing (5) and shaft (4) in it's original position.
NOTE: Verify boot is not twisted and remove any excess air.
9. Measure the distance from the end of the housing to the end of the boot on the shaft. This measurement should be 260 mm (10.25 in.).
NOTE: If measurement is not correct, allow more or less air into the boot.
10. Secure both boot clamps (1) (3) with Clamp Installer C-4975A. Place tool on clamp bridge and tighten tool until the jaws of the tool are closed.