RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Wheel Bearing: Service and Repair
Removal
3500 CAB CHASSIS
1. Raise and support the vehicle See: Maintenance.
2. Remove the wheel and tire assembly.
3. Remove the hub extension (1) mounting nuts and remove the extension from the rotor if equipped.
4. Remove the brake caliper, See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Disc Brake Caliper - Removal.
5. Remove the cotter pin (2) and the hub nut (1) from the axle shaft.
6. Remove the caliper adapter. See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Disc Brake Caliper Adapter - Removal.
7. Remove the disc brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal.
8. Disconnect the wheel speed sensor wire.
9. Remove the hub/bearing 4 mounting bolts and remove the hub/bearing.