RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic
brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the
area of repair instead of the entire system.
2. Raise and support the vehicle.
3. Remove the brake line (3) from the hose (1) at the frame.
4. Remove the brake hose clip (2) at the top of the hose located at the frame.
5. Remove the vent hose (2).
6. Remove the two brake lines (3) at the bottom of the hose (1) located at the axle.
7. Remove the mounting bolt for the brake hose at the axle.
8. Remove the hose.
Rear Tube / Hose Assembly
REAR TUBE / HOSE ASSEMBLY
1. Install the hose (3).
2. Install the banjo bolt (1) at the caliper and tighten fitting bolt to 27 Nm (245 in. lbs.).
3. Install the mounting bolt (2) for the brake hose (3) at the axle.
4. Install the brake line located at the axle.
5. Lower the vehicle and remove the support.