RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
Engine Oil Control Valve: Procedures
Cleaning
CLEANING
1. Clean the regulator spring and plunger with a suitable solvent and blow dry with compressed air. If the plunger bore requires cleaning, it is
necessary to remove the oil filter head to avoid getting debris into the engine.
Inspection
INSPECTION
Inspect the plunger and plunger bore for cracks and excessive wear. Polished surfaces are acceptable. Verify that the plunger moves freely in the bore.
Check the spring for height and load limitations. Replace the spring if out of limits shown in the figure.