RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
Brake Light Bulb: Service and Repair
Installation
Bulb - Cab And Chassis
BULB - CAB AND CHASSIS
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The rear lamp unit contains two bulbs: the park/turn signal/brake/license plate, and the backup. The service procedures for each bulb are the
same, only the bulb sizes and types may differ.
1. Align the base of the backup lamp bulb (4), or the park/turn signal/brake/license plate lamp bulb (7) with its socket (3) or (6).
2. Push the bulb straight into the socket until the base is firmly seated, then rotate the bulb clockwise about 30 degrees to lock it into place.
3. Position the lens (2) to the rear lamp unit housing (5).
4. Install and tighten the four screws (1) that secure the lens to the housing. Tighten the screws to 2 Nm (20 in. lbs.).
5. Reconnect the battery negative cable.
Bulb - Pick-Up
BULB - PICK-UP
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.