RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
INSTALLATION
EGR COOLER - 6.7L DIESEL
WARNING: Locking constant tension hose clamps are used on the EGR cooler system hoses. When removing or installing, use only tools
designed for servicing this type of clamp. Always wear safety glasses when servicing locking constant tension clamps.
1. Using a new gasket, position EGR cooler (2) on flange.
2. Install flange nuts (1). Tighten to 10 Nm (89 in. lbs.).
3. Install EGR cooler mounting bolts. Tighten to 10 Nm (89 in. lbs).
4. Install EGR crossover tube (5) and crossover tube clamp (4). Tighten clamp nut to 10 Nm (89 in. lbs.).
5. Install EGR Transfer Connection Tube into casting, (if equipped). Tighten clamp nut to 10 Nm (89 in. lbs.).
CAUTION: Locking constant tension clamps will SNAP when released.
NOTE: Locking constant tension clamps can be released using a suitable screwdriver.
6. Position locking constant tension clamp (1) on froward coolant tube (4) and install tube.
7. Using a suitable screwdriver (3), release constant tension clamp (1).
8. Position locking constant tension clamp on rear coolant tube and install tube.
9. Using a suitable screwdriver, release constant tension clamp
10. Position locking constant tension clamp on breather tube and install tube.
11. Using a suitable screwdriver, release constant tension clamp.
