RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
Keyless Start Antenna: Service and Repair
Removal
REMOVAL
The Remote Start Antenna Module Assembly consists of an electrical connection to the WCM/SKREEM (1), a length of coax cable (2), two mounting
clips (3) and (4), and a control module/antenna (5).
The control module (1) is located behind the instrument panel cluster. The module electrical connector plugs into the WCM/SKREEM at the right side of
the steering column.
1. Disconnect and isolate negative battery cable.
2. Remove steering column trim panel (knee blocker).
3. Remove steering column shrouds.
4. Remove IP cluster bezel.
5. Remove IP cluster and its three connectors.
6. Remove two module mounting screws (2) from module (1).