RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
1. Position the steering knuckle (1) on the ball stud.
2. Install and tighten lower ball stud nut (3) to 47 Nm (35 ft. lbs.) torque.
3. Install the upper ball joint (2) into the steering knuckle Tighten to make sure the wheel speed sensor bracket (3) for the wire is installed
between the knuckle and ball joint (2).
4. Install and tighten upper ball stud nut (1) to 94 Nm (70 ft. lbs.) torque.
5. Retorque lower ball stud nut to 200 Nm (148 ft. lbs.) torque.
6. Install the hub bearing and tighten the bolts (1) to See: Wheel Bearing/Service and Repair/Front Hub / Bearing - Installation .