RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
15. Remove manual lever (2) and throttle lever (3). Rotate and lift manual lever off valve body and throttle lever shaft. Then slide throttle lever out of
valve body.
16. Position pencil magnet (4) next to detent housing to catch detent ball and spring. Then carefully remove Retainer Tool 6583 and remove detent
ball (3) and spring (2).
17. Remove screws (2) attaching pressure adjusting screw bracket (3) to valve body and transfer plate. Hold bracket (5) firmly against spring tension
while removing last screw (5).
18. Remove adjusting screw bracket (4), line pressure adjusting screw (2), pressure regulator valve spring (5), and switch valve spring (1). Do not
remove throttle pressure adjusting screw from bracket and do not disturb setting of either adjusting screw during removal.