RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
Axle Bearing: Service and Repair
Rear Axle - 9 1/4
Removal
REMOVAL
1. Remove axle shaft.
2. Remove axle shaft seal from axle tube with a small pry bar.
NOTE: The seal and bearing can be removed at the same time with the bearing removal tool.
3. Remove axle shaft bearing with Bearing Remover 6310 (2) (3) (4) (5) and Foot 6310-9 (7).
Installation
INSTALLATION
1. Wipe axle tube bore clean and remove any old sealer or burrs from the tube.
2. Install axle shaft bearing with Installer C-4198 and Handle C-4171. Drive bearing in until tool contacts the axle tube.
NOTE: Bearing is installed with the bearing part number against the installer.
3. Coat lip of the new axle seal with axle lubricant and install with Installer C-4076-B and Handle C-4735.
4. Install the axle shaft (1).
5. Install differential cover and fill with gear lubricant to the bottom of the fill plug hole.