RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Electronic Brake Control Module: Service and Repair
Installation
INSTALLATION
NOTE: If the ABM is being replaced with a new ABM is must be reprogrammed with the use of a scan tool.
1. Install ABM to the HCU.
2. Install the pump connector to the ABM.
3. Install mounting bolts. Tighten to 2 Nm (16 in. lbs.).
4. Install the wiring harness connector to the ABM and push down on the release to secure the connector.
5. Install negative battery cable to the battery.
