dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Air Bag Control Module|Removal|Page 669 > < Air Bag Control Module|Removal|Page 667
Page 1
background image

Air Bag Control Module: Service and Repair
Installation

Module

MODULE

WARNING:  To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.

WARNING:  To avoid serious or fatal injury, never strike or drop the occupant restraint controller, as it can damage the impact sensor or
affect its calibration. The occupant restraint controller contains the impact sensor, which enables the system to deploy the supplemental
restraints. If an occupant restraint controller is accidentally dropped during service, the module must be scrapped and replaced with a new
unit. Failure to observe this warning could result in accidental, incomplete, or improper supplemental restraint deployment.

1. Position the Occupant Restraint Controller (ORC) (1) over the three studs of the ORC mounting bracket (3) on the floor panel transmission tunnel,

then engage the locating pin on the bottom of the right ORC mounting flange into the locating hole in the bracket. When the ORC is correctly
positioned, the arrow on the ORC label will be pointed forward in the vehicle.

2. Install and tighten the three nuts (2) that secure the ORC to the bracket on the floor panel transmission tunnel. Tighten the nuts to 10 Nm (7 ft.

lbs.).

3. Reconnect the two wire harness connectors (3) for the ORC (1) to the ORC connector receptacles (2 and 4) located on the forward facing side of

the module. Be certain that the latches on the connectors are each fully engaged.

4. Reinstall the ORC cover onto the ORC.

Air Bag Control Module|Removal|Page 669 > < Air Bag Control Module|Removal|Page 667