RAM 3500 Van V8-360 5.9L Magnum (1995)
Cruise Control Servo: Service and Repair
1. Disconnect battery ground cable.
2. Disconnect vacuum hose, then the electrical connector from servo.
3. Remove two nuts from servo mounting bracket, then pull servo away from bracket.
4. Remove, push nuts from servo studs, then discard.
5. Pull speed control cable away from servo far enough to expose cable retaining clip.
6. Remove clip attaching cable to servo, then servo from vehicle.
7. Reverse procedure to install, noting the following:
-
Torque both attaching nuts to 50 inch lbs.