RAM 4500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
PERFORM SERVICE INDICATOR - RESET
The "Perform Service" message will display on the Electronic Vehicle Information Center each time you turn the ignition switch to the ON/RUN
position to indicate a emission maintenance is required. To reset the "Perform Service" indicator system (after performing the scheduled maintenance)
refer to the following procedure:
-
1. Turn the ignition switch to the ON position (Do not start engine).
-
2. Press and release the brake pedal two times.
-
3. Fully depress the accelerator pedal slowly two times within 10 seconds.
-
4. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illumination when you start the vehicle, the "Perform Service" indicator did not reset. If necessary repeat this
procedure.