RAM 4500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
O-ring seals as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C
compressor in the vehicle.
4. Connect the front section of the A/C liquid line to the rear section of the liquid line (3) See: Heating and Air Conditioning/Coupler HVAC/Service
and Repair/Installation .
5. Install the secondary retaining clip (2) onto the spring-lock coupler that secures the front section of the A/C liquid line onto the rear section of the
liquid line.
6. Engage the A/C liquid line (1) into the three body retaining clips (2 and 3) located at the right front corner of the engine compartment.
7. Lubricate a new O-ring with clean refrigerant oil and install it and a new gasket onto the front liquid line fitting. Use only the specified O-ring seal
as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
8. Connect the front section of the A/C liquid line (2) to the condenser port.
9. Install the nut (1) that secures the A/C liquid line to the A/C condenser (3). Tighten the nut to 23 Nm (17 ft. lbs.).
10. Position the air seal over the right end of the A/C condenser and install the air seal retainers.
11. Install the passenger side battery tray See: Starting and Charging/Battery/Battery Tray/Service and Repair/Battery Tray - Installation .
12. Reconnect the negative battery cable(s).
13. Evacuate the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Evacuate .
14. Adjust the refrigerant oil level See: Heating and Air Conditioning/Service and Repair/Refrigerant Oil Level .
15. Charge the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Charge .
REAR SECTION