RAM 50 2WD L4-156 2556cc 2.6L VIN 7 2-bbl (1983)
Alignment: Service and Repair
Camber
FRONT
WITH TWO WHEEL DRIVE
1. Using tool No. MB990805 to hold upper arm shaft to crossmember bolt in position, remove nut from engine compartment side and adjust the
number of shims between upper arm shaft and crossmember.
2. The normal shim pack thickness is 0.16 inch. A change of 0.024 inch in thickness of the shim pack will provide a change of approximately 2/15
degree in camber adjustment.
WITH FOUR WHEEL DRIVE
Adjust number of shims between upper arm shaft and arm post of side frame. The normal shim package thickness is 0.12 inch. A change of 0.039 inch
in thickness of shim pack will provide a change of approximately 13 minutes in camber adjustment. Camber adjusting shims are available in
thicknesses of 0.039 and 0.079 inch.
REAR
Rear camber is pre-set during vehicle assembly and cannot be adjusted. If camber is not within specifications, check for worn or damaged suspension
component, and damaged or deformed floor pan or body and repair as needed.
