RAM 50 2WD L4-156 2556cc 2.6L VIN 7 2-bbl (1983)
proper alignment.
d. Using a suitable spring scale or torque wrench, measure force required to rotate front hub.
e. The force required to rotate the front hub assembly should be 1.1-4.0 lbs. (spring scale) or 3-11 inch lbs. (torque wrench), and endplay should
be less than 0.002 inch. If rotating force is not within specifications, repeat adjustment.
f.
When adjustment is correct, secure washer with retaining screws.
8. On models with automatic locking hubs, measure brake contact surface depth as follows:
Fig. 15 Measuring brake contact surface depth. Automatic locking hub
a. Measure dimension A, in two places using suitable depth gauge.
b. Average of two readings should be 0.46-0.48 inch. If depth is greater than specified, install suitable shims. If depth is less than specified,
recheck hub and bearing installation.
9. Apply grease to inner surface of free wheeling hub body assembly.
10. Apply semi-dry sealant to front hub surface to which the free wheeling hub body assembly is attached.
11. Align tab on free wheel hub with groove on spindle, install free wheeling hub body assembly on front hub, then torque attaching bolts to 37-43 ft.
lbs.
12. Reverse remaining procedure to complete installation.
