RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
3. Move the load floor (3) to the down position and install the two nuts (2) that secure the load floor to the floor panel. Tighten the nuts to 25 Nm (18
ft. lbs.).
4. Move the rear seat cushion (1) to the down position.
Removal
REMOVAL
1. Using a small flat-bladed tool, carefully open the two fastener covers (3) located in the a-pillar trim panel (2).
2. Remove the two bolts (4) that secure the a-pillar trim panel to the a-pillar (1) and remove the trim panel.
Installation
INSTALLATION