RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
INSTALLATION
NOTE: On a new vehicle or after parking brake lining replacement, it is recommended that the parking brake system be conditioned prior to
use. This is done by making one stop from 25 mph on dry pavement or concrete using light to moderate force on the parking brake foot pedal.
1. Reassemble the rear park brake shoes (1) or.
2. Install the axle shaft (1) See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Axle Shaft/Service and
Repair/Rear Axle - 9 1/4/Installation or See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Axle
Shaft/Service and Repair/Rear Axle - 11 1/2 AA/Installation .
3. Install the park brake cable to the lever behind the support plate.
4. Unlock the park brake cable.
5. Install the disc brake rotor See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Installation .
6. Install the disc brake caliper See: Disc Brake System/Brake Caliper/Service and Repair/Removal and Replacement/Disc Brake Caliper -
Installation .
7. Adjust the rear brake shoes See: Parking Brake System/Parking Brake Shoe/Adjustments .
8. Install the tire and wheel assembly See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement .
9. Lower the vehicle.