RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
Accelerator Pedal Position Sensor: Service and Repair
Removal
REMOVAL
CAUTION: Do not attempt to separate or remove the Accelerator Pedal Position Sensor (APPS) from the accelerator pedal assembly. The
APPS is replaced as an assembly along with the pedal. If sensor is removed from pedal, its electronic calibration may be destroyed.
1. Disconnect 6-way electrical connector at top of APPS (2).
2. Remove APPS lower mounting bolt (4) and two mounting nuts.
3. Remove pedal and APPS assembly from vehicle.