RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
12. Remove both valve body electrical harnesses (1) from the transmission case.
Installation
INSTALLATION
CAUTION: If the valve body is being replaced the oil pump must also be replaced. Failure to follow these instructions will damage the
transmission.
NOTE: If the valve body is being replaced, a quick learn must be performed using the scan tool. See: Transmission Control Systems/Testing and
Inspection/Programming and Relearning/Transmission Control Module/TCM Quick Learn
NOTE: Apply petroleum grease to all slide portions, rolling contacts surfaces, thrust surfaces etc. to prevent burnout during initial operation.
Lubricate O-rings and O-ring seals with MOPAR(R) AS68RC ATF. Soak all friction disks in MOPAR(R) AS68RC ATF for at least two hours
before assembly of clutch packs.
1. Lubricate the seals on the electrical connectors with MOPAR(R) AS68RC ATF and install the valve body electrical harnesses (1) into the
transmission case.