RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
8. Install stub shaft yoke (1) on U-joint cross (2).
9. Tap fist bearing cap into the stub shaft yoke bore far enough to position cross.
10. Position receiver/socket (1) on shaft yoke (2) and driver/socket on bearing cap in press.
11. Press bearing cap into stub shaft yoke until bearing cap snap ring groove is visible and install snap ring.
12. Position receiver/socket (1) on stub shaft yoke and driver/socket (2) on bearing cap in press.
13. Press bearing cap into stub shaft yoke until bearing cap snap ring groove is visible and install snap ring.