RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
7. Install the hub extension and nuts to the front rotor. Tighten nuts to 130 Nm (96 ft.lbs). HD DRW ONLY.
8. Install the wheel and tire assemblies, See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement .
9. Remove the support and lower the vehicle.
10. Apply the brakes several times to seat the brake shoes and caliper piston. Do not move the vehicle until a firm brake pedal is obtained.
4500 & 5500 - Link/Coil
4500 & 5500
NOTE: If installing a NEW hub/bearing on a 4X4 only Steps 1-3 should be followed for the correct shim size.
1. Measure from the new hub/bearing unit crimp (2) to the flange (3).
2. Choose the correct shim according to the table:
3. Check the shim (2) on the axle shaft (3). Be sure that the shim (2) is placed with the radius side (1) to the joint.
4. Install the hub/bearing to the knuckle. Tighten the hub/bearing bolts (1) to 202 Nm (149 ft. lbs.