Ram Raider V6-2972cc 3.0L SOHC (1989)
Distributor: Service and Repair
Component Overview
REMOVAL:
1.
Disconnect battery ground cable.
2.
Remove retaining clips, distributor cap and seal ring.
3.
Place an alignment mark on distributor body and engine block, indicating position of distributor body in block or cylinder head. Place No. 1
cylinder to TDC of compression stroke. Place another mark on distributor body indicating position of rotor. Do not use a sharp tool to place
alignment marks on distributor body and engine block or cylinder head.
4.
Disconnect wiring harness from distributor lead wire.
5.
Remove distributor mounting nut, then the distributor assembly from engine.
INSTALLATION:
1.
Turn the crankshaft so that the No.1 cylinder is at top dead center.