RAM SRT-10 Pickup V10-505 8.3L (2004)
CAUTION: Do not exceed 52 degrees C (120 degrees F) when heating the moldings or rocker panels. Failure to follow this caution may
result in damage to the moldings and/or the vehicle paint finish.
NOTE: If ambient temperatures are below 21 degrees C (70 degrees F), warm the body side molding and rocker panel with a heat lamp or gun
to assure proper adhesion.
3. Remove the protective covering from the back of the body side molding (2 and 3) and position the molding onto the rocker panel using the
previously installed guide tape.
NOTE: To ensure proper molding adhesion, apply consistent and uniform pressure of approximately 40 p.s.i. over the entire surface of each
body side molding.
4. Install the body side molding onto the rocker panel.
