RAM SRT-10 Pickup V10-505 8.3L (2004)
1. Install a new rubber grommet seal into the washer fluid level switch mounting hole in the washer reservoir (2). Always use a new rubber grommet
seal on the reservoir.
2. Insert the float of the washer fluid level switch (5) through the rubber grommet seal and into the washer reservoir. The connector receptacle of the
washer fluid level switch should be pointed upward.
3. Using hand pressure, press firmly and evenly on the washer fluid level switch mounting flange until the barbed nipple is fully seated in the rubber
grommet seal in the washer reservoir mounting hole.
4. Reconnect the left headlamp and dash wire harness (1) connector for the washer fluid level switch to the switch connector receptacle.
5. Reconnect the removed washer hose (4) to the barbed outlet nipple of the washer pump/motor unit (3).
6. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
7. Reconnect the battery negative cable.
8. Close and latch the hood.